Leroy-Somer Digidrive SK Serie Guía De Usuario página 84

Français
Action
Ensure:
•
Before power up
•
•
•
Ensure:
Power up the
drive
•
Enter minimum Enter:
and maximum •
speeds
•
Enter
Enter:
acceleration and
•
deceleration
•
rates
Enter:
Set keypad
control
•
Enter:
•
Enter motor
•
nameplate •
details
•
•
Ready to autotune
Close:
Enable and run
•
the drive
•
The Digidrive SK will carry out a non-rotating autotune on
the motor. The display will flash alternatively between 'Auto'
and tunE' to show that an autotune is being carried out on
the motor.
Autotune The motor must be stationary to carry out an autotune
correctly.
The drive will carry out a non-rotating autotune every time it
is first started after each power-up. If this will cause a
problem for the application, set Pr 41 to the required value.
When the autotune has been completed, the display will show:
Autotune
complete
Ready to run
Run The drive is now ready to run the motor.
Press the
Increasing and
decreasing speed
Press the
Stopping
Press the
To implement a Forward/Reverse switch, see the Digidrive SK Advanced User Guide.
NOTE
84
English
The drive enable signal is not given, terminal B4 is open
The motor is connected to the drive
The motor connection is correct for the drive ∆ or Y
The correct supply voltage is connected to the drive
The drive displays:
Minimum speed Pr 01 (Hz)
Maximum speed Pr 02 (Hz)
Acceleration rate Pr 03 (s/100Hz)
Deceleration rate Pr 04 (s/100Hz)
PAd into Pr 05
Motor rated current in Pr 06 (A)
Motor rated speed in Pr 07 (rpm)
Motor rated voltage in Pr 08 (V)
Motor rated power factor in Pr 09
If the motor is not a standard 50/60Hz motor, set Pr 39
accordingly
The enable signal
Press the RUN key
UP key to increase the speed
DOWN key to decrease the speed
STOP/RESET key to stop the motor
Deutsch Italiano
Detail
Digidrive SK Getting Started Guide
Español
Pr 02
Pr 01
t
100Hz
t
Pr 03 Pr 04
Mot X XXXXXXXXX
No XXXXXXXXXX kg
°
IP55 I.cl F C 40 s S1
-1
V Hz min kW cosφ A
230 50 1445 2.20 0.80 8.50
400 4.90
CN = 14.5Nm
240 50 1445 2.20 0.76 8.50
415 4.90
CN = 14.4Nm
CTP- VEN 1PHASE 1=0,46A P=110W R.F 32MN
cos ∅
R
S
σL
S
Issue Number: a