SWM RS 300 R 2017 Manual - Uso - Mantenimiento página 116

REASSEMBLING THE FRONT WHEEL
Fit the L.H. spacer (D) on the wheel hub.
Fit the wheel between the fork legs so as to set the
brake disc into the calliper.
Fit the wheel axle (2) from the R.H. side, after greas-
ing it and push it fully home against the L.H. fork leg;
during this operation, the wheel should be turned.
Tighten the screw (3) on the fork L.H. side but DO
NOT lock it.
D
1
EN - 44
Now, pump for a while, pushing the handlebar
downwards until you are sure that the fork legs are
perfectly aligned. Lock: the screws (1) on the R.H. leg
(7.67 ft-lb), the screw (3) on the L.H. side (37.95 ft-lb),
the screws (1) on the L.H. leg (7.67 ft-lb).
2
3
Note*: After reassembly, pull the brake control le-
ver until the pads are against the brake disc.
1