Headlamp Bulbs Replacement - SWM RS 300 R 2017 Manual - Uso - Mantenimiento

HEADLAMP BULBS REPLACEMENT

To gain access to the healamp bulbs, proceede as
follows:
- remove the upper fastening screw of the the
headlamp carrier to the instrument panuel sup-
port (A);
- push forward the headlamp carrier (B) and pull
it towards the high (C) in order to uncouple
from the two lower supports.
- remove the headlamp carrier;
A
EN - 60
- remove the two filaments bulb connector (1)
and the boot (2);
- remove the screw (3);
- release the bulb holding spring (4) and then the
bulb (5) itself.
Note*: Headlamp bulb (5) is of the halogen type; be
careful when replacing it since the glass part shall
not be touched with bare hands.
To replace the position light bulb (6), disconnect the
connector (7) and remove it from the internal cap.
After replacement, reverse operations for reassem-
bly.
C
B
3
4
5
7
6
2
1