Cleaning The Lift - Nussbaum SMART LIFT 2.30 SL Instrucciones De Servicio

Time frame Type of
maintenance
12
1
11
2
10
1 x / 12
9 3
4
8
5
7
6
12
1
11
2
10
1 x / 12
9 3
4
8
5
7
6
12
1
11
2
10
365 x / 12
9 3
4
8
7 5
6
12
1
11
2
10
1 x / 12
9 3
4
8
5
7
6
7.2

Cleaning the lift

A regular and expert clean helps retain the value of
the lift. Additionally, it can also be a pre-requisite for
the preservation of guarantee claims for any even-
tual corrosion damage.
The best protection for the lift is regular removal of
contaminants of any kind.
This includes above all:
• De-icing salt
• Sand, pebbles, earth
• Industrial dust of all types
• Water, also in connection with other environmen-
tal influences
• Aggressive deposits of all types
• Permanent humidity due to insufficient ventilation
OPI_SMART LIFT 2.30 SL-2.35 SL-2.40 SL - HYMAX S 3000-S3500-S4000_V1.2_DE-EN-FR-ES-IT
Maintenance plan
Check the paint:
• Check the powder coating and improve if required. Dam-
age by external influences is to be treated immediately af-
ter detection. If these points are not treated, infiltration of
deposits of all kinds can cause wide-ranging and perma-
nent damage. These points are to be lightly sanded (120
grit), cleaned and degreased. Afterwards, rework with a
suitable touch up paint (note the RAL No.).
• Check galvanized surfaces, touch up as needed. White rust
is fostered by permanent humidity, poor ventilation. The af-
fected areas can be treated by using a sanding cloth (A
280 grit). If required, the parts are to be treated with a suit-
able, resistant material (paint etc.). Check the RAL colour
selection.
• Rust is brought out by mechanical damage, wear, aggres-
sive deposits (de-icing salt, leaking operating fluids) clean-
ing that is not done or incomplete. The affected areas can
be treated by using a sanding cloth (A 280 grit). If required,
post-treat the areas with a resistant material (paint etc.).
Check electrical components for damage.
• Plug
• Reversing switch and LED display
• During assembly and maintenance always check the con-
dition of electrical lines. All cables and lines must be secured
so they cannot be crushed, kinked or contact any rotating
components (e.g. V-belt disc, etc.).
Optional energy set:
• Electrical socket
• Pneumatic connection
Check for damage. Check function.
The frequency of lift cleaning depends, among oth-
er things on the frequency of use, of lift handling,
of workshop cleanliness, and the location of the
lift. Furthermore, the degree of contamination de-
pends on the time of year, the weather conditions
and workshop ventilation. Under adverse circum-
stances, weekly lift cleaning might be required,
however a monthly cleaning may be sufficient.
Do not use and aggressive and abrasive materials
for cleaning, rather use mild cleaners, e.g. a com-
mercially available detergent and lukewarm water.
• For cleaning, do not use high pressure washers
(e.g. steam cleaners)
• Carefully remove all contamination with a
sponge, or if required with a brush.
Pos.
115