Sandman Duo™ Settings - Puritan Bennett Sandman Duo Manual De Utilización

Sandman Duo™ settings
See "" on page 44 for general descriptions of a screen page and the buttons and
symbols.
Note:
Pressing the right control button
screen to display.
1) Humidification level
Views of the display
Once the settings are made, select the page header by using the ramp button or the
on/off button, then press the right control button
Note:
2) Settings
In CPAP mode
View of the display
The first parameter is accessible by pressing the ramp button.
Sandman Duo/DuoST Patient Manual
In the following screens, the values displayed are given by way of
example.
Note: This screen displays only if the device is equipped with the
The symbol indicates that the heat level can be modified. The heat
level can be set in increments of 1 from 0 to 10.
Press the ramp button to select the setting.
The value may be increased by using the right control button
decreased by using the left control button
at 10, the heating element delivers maximum heat.
If the humidifier indicator at the top of the screen blinks (without the
humidification level value) when the device is in standby (i.e., when the time is
displayed) or when the device is operating (i.e., when the pressure is displayed),
pressing on the settings button
appear. If the device is connected to a battery, the heated humidification function
cannot be used and the symbol blinks. In the other cases, contact your home
care provider.
Comfort pressure: Level of pressure produced by the device when the
ramp feature starts up.
Ramp time: Time the device takes to reach the prescribed pressure when
starting from the comfort pressure.
Pressure: Set pressure, level of pressure prescribed, which may be
±
altered by
Alter feature has been selected.
Note: This page will display only if the maximum ramp time is other than
(Item 5 of Figure 3 on page 7) causes the following
humidification feature.
will cause the blinking
. The set pressure will display only if the Pressure
1 cmH O
2
0 (see Screen Parameters) and/or if the Pressure Alter
function is activated. (see paragraph "3) Parameters").
. When the heat setting is
to access the next page.
and
symbol to
US – 19