Puritan Bennett Sandman Duo Manual De Utilización página 26

The page will change as follows:
Views of the display
Press the ramp button to access the next parameter on the menu.
Press the ramp button to access the next parameter on the menu
In Bi-level mode
Views of the display
The first parameter on the menu can be accessed by pressing the ramp button. The
symbols displayed in the lower part of the screen will change as shown in the following.
Press the ramp button to access the next parameter on the menu.
Once the settings are made, select the page header by using the ramp button or the
on/off button, then press the right control button
US – 20
The comfort pressure value is selected and can be set in increments of
0.5 cmH O from 3 cmH
2
device is in standby. Press the right control button
setting and the left control button
The ramp time value can be set in increments of 5 minutes from 0 (ramp
disabled) to the maximum ramp time prescribed, but only when the
device is in standby. Press the right control button
setting and the left control button
Note: This setting can also be accessed by pressing the ramp button,
but only when the device is in standby.
The set pressure value does not display unless the Pressure Alter feature
is selected. It can be set in increments of
±
pressure 1 . Press the right control button
cmH O
2
and the left control button
to 20 .
cmH O
2
This page displays only when at least one parameter is adjustable.
Otherwise, it does not display.
Comfort pressure: Level of pressure produced by the device when the
ramp feature starts up.
Ramp time: Set time to reach the inspiratory positive airway pressure
(IPAP) and the expiratory positive airway pressure (EPAP) when starting
from the comfort pressure.
Note: This page does not display unless the maximum ramp time is other
than 0 (see the Parameters screen). The Pressure Alter
feature is unavailable in Bilevel mode.
The comfort pressure value displays only if the ramp can be activated.
The value selected can be set in increments of 0.5 cmH
up to the expiratory positive airway pressure (EPAP), but only when the
device is in standby. Press the right control button
setting and the left control button
The ramp time value can be set in increments of 5 minutes from 0 (ramp
disabled) to the maximum ramp time prescribed, but only when the
device is in standby. Press the right control button
setting and the left control button
Note: This setting can also be accessed by pressing the ramp button,
but only when the device is in standby.
O up to the set pressure, but only when the
2
to lower it.
to lower it.
to lower it within the limit from 3
to lower it.
to lower it.
to access the next page.
Sandman Duo/DuoST Patient Manual
to raise the
to raise the
.
to the prescribed
0.5 cmH O
2
to raise the value
O from 3 cmH
2
to raise the
to raise the
cmH O
2
O
2