Beta URBAN 125 Manual Del Usuario página 130

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

3
ENGINE OIL AND OIL FILTER URBAN125
Check
Keep the vehicle in an upright position.
The engine is cold, check for the pres-
ence of oil.
Topping up
To restore the level, remove cap A and
top up.
Renewal
A
Always renew the oil when the engine
is hot. To avoid burns, take care not to
touch the engine and the oil.
• Put the vehicle on its stand.
• Extract the two screws D and fastening
E, and then remove protection C.
• Place a container under the engine.
• Unscrew fi ller plug A and drain plug B.
• Drain all the oil from the crankcase.
• Close plug B.
• Pour in 1000 cc of fresh oil.
• Screw on fi ller cap A again.
B
WARNING
Hot oil can cause severe burns.
Note:
the URBANI25 engine contains the
rotary oil fi lter, which is mounted on the
clutch side of the drive shaft. To replace
it, contact a licensed Betamotor dealer.
Note:
Renew the engine oil after the fi rst 500
km. For the renewal intervals, refer to the
table on page 63. Only use the lubricants
recommended on page 43.
IMPORTANT
Dispose of used oil in compliance with
the regulations in force.
GB
50

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Urban 200

Tabla de contenido