Removing The Stand - Beta URBAN 125 Manual Del Usuario

3
How to remove the plate holder
To remove the back plate holder A inclu-
ding the lights and indicators, fi rst remove
the saddle (see previous page), then:
•loosen the three screws and the fi xing
nuts B of the back plate holder.
•disconnect the electric connections of the
back lights and remove the plate holder A.
WARNING:
The motorbike cannot be driven without
a plate holder and/or lights. It can only
be driven in private tracks and/or traffi c-
barred areas.
Removing
Remove the front mudguard by unscrewing
the 4 fi xing screw C.

Removing the stand

•Remove the fi xing system D (screw and
nut).
•Pull out the stand E while taking care not
to lose the draw spring F.
Notes:
while disassembling the motorbike, take
care not to damage the magnet and the
stand sensor G.
Removing the passenger's footrests
• Loosen the two screws Hshown in the fi g-
ure and remove the passenger's footrest
complete with the frame fi xing support.
How to remove the helmet lock
To remove the helmet lock, just remove
the two screws I.
GB
the front mudguard
B
G
E
I
60
A
C
D
F
H