Electrical Connection - Beem Espresso Perfect Crema Plus Manual De Instrucciones

Commissioning

Electrical connection

EN
48
For safe and trouble-free operation of the appliance, the following
instructions have to be observed for the electrical connection:
Before connecting the appliance, compare the connection data
■
(voltage and frequency) on the rating plate with those of your
mains power supply. The data have to correspond in order to
avoid damage to the appliance. If in doubt, ask your electrical
appliance dealer.
The plug socket must be protected by at least a 10 A circuit
■
breaker.
If the appliance is to be connected to the power supply via an
■
extension lead, the cable cross-section must be at least 1.5
mm².
Ensure that the connecting lead is undamaged and is not laid
■
over hot surfaces or sharp edges.
The connecting lead must not be strained, kinked or come into
■
contact with the hot appliance or hot surfaces.
Lay the connecting lead in such a way that it does not pose a
■
tripping hazard.
The electrical safety of the appliance is only assured when it is
■
connected to a properly installed protective earth (PE) conductor
system. Connection to a plug socket without PE conductor is
forbidden. If in doubt, have the house installation checked by a
qualified electrician. The manufacturer assumes no liability for
injury or damage caused by a missing or interrupted protective
earth conductor.
BEEM - Elements of Lifestyle