Harbor Breeze 40190 Manual De Instrucciones página 10

STANDARD OR ANGLE MOUNTING INSTRUCTIONS
3 . Slide the downrod (A) into the yoke of the motor
assembly (E), align the holes, then re-install the
downrod clip (FF) and downrod pin (EE) . Secure
with motor housing set screws (GG) and slide the
yoke cover (F) down until it rests on top of the motor
assembly (E) .
Haodwaoe Used
EE
Downrod Pin
FF
Downrod Clip
Motor Housing
GG
Set Screw
4 . Depending on the length of downrod you use, you
may need to cut the lead wires back to simplify the
wiring . If you decide to cut back the lead wires, it is
suggested you do so in the following manner: Take
the lead wires and make sure you have pulled them
all the way through the top of the downrod . Measure
8 inches of lead wire, then cut the excess wire off
with wire cutters (not included) .
3
x 1
x 1
x 2
4
10
F
FF
E
Lowes.com/harborbreeze
A
EE
GG