Harbor Breeze 40190 Manual De Instrucciones página 19

TROUBLESHOOTING
PROBLEM
There is excessive
wobbling .
The fan operates
correctly, but the
lights are not
working .
POSSIBLE CAUSE
1 . The blades and/or blade are
loose .
2 . The blades are unbalanced .
3 . The fan mounting is not
secure .
4 . The fan is too close to the
vaulted ceiling .
5 . The set screw on the motor
housing yoke is loose .
1 . The bulbs are not installed
correctly .
2 . The light kit wire plugs are
not connected properly .
3 . There is a faulty wire
connection .
4 . The total power of the light is
exceeding 190W .
CORRECTIVE ACTION
1 . Check and tighten all screws that hold
the fan blades to the blade arms and
the blade arms to the motor .
2 . Switch one blade with a blade from
the opposite side . Or balance the fan
using a balancing kit (not supplied) .
3 . Turn off the power . Loosen the
canopy and verify that the mounting
bracket is secure to the electrical
outlet box. The bracket must be flush
without movement against the outlet
box .
4 . Use a longer downrod or move the
fan to another location .
5 . Lift up the yoke cover and tighten the
set screw to the yoke until secure .
1 . Re-install the bulb(s) .
2 . Ensure that the male and female
plugs in the light kit fitter are
connected properly .
3 . Turn the power off and check all
connections at the ceiling outlet box .
4 . The fan comes with a 190W limiter .
When the total watts of the lights is
over 190W, the lights do not work .
Please replace the bulbs with lower
wattage bulbs .
19
Lowes.com/harborbreeze