Harbor Breeze 40190 Manual De Instrucciones página 15

FINAL INSTALLATION
3 . Partially insert three blade screws (BB), along with
three blade washers (CC) through one blade (H)
and into one blade arm (G) . Tighten each blade
screw (BB) with a Phillips screwdriver (not included),
starting with the one in the middle . Repeat this step
for the remaining blades (H) and blade arms (G) .
Haodwaoe Used
BB
Blade Screw
CC
Blade Washer
4 . Insert blade arm (G) through slots in the side of the
motor assembly (E) . Align the holes of one blade
arm (G) with two motor screw holes in underside
of the motor assembly (E) . Secure with two motor
screws (AA) . Repeat this step for the remaining
blade arms (G) .
Haodwaoe Used
AA
Motor Screw
5 . Remove one of the four fitter plate screws (II) located
on the underside of the motor assembly (E) and
loosen the other three screws . Align the screw holes
of the light kit plate (L) with the loosened fitter plate
screws (II). Replace previously removed fitter plate
screw (II), then tighten all screws .
Haodwaoe Used
Fitter Plate
II
Screw
3
BB
CC
x 15
x 15
4
x 10
E
5
E
x 4
15
G
AA
II
Lowes.com/harborbreeze
H
H
G G
L