Using Your Ceiling Fan - LUCCI Air AIRFUSION BANKSIA DC Manual De Instrucciones De Instalación

Banksia Fan Installation Instructions
BATTERY INSTALLATION
1 x 23A 12V battery is required to operate the remote control. Pull out the
battery cover and install the battery. Ensure the polarity is correct as shown
in the battery compartment.
OPERATING THE REMOTE
Before you start using the remote, take the time to read through this section and get familiar with the buttons
and function of each button.
NOTE: when you turn on the fan for the first time or switch the main power to the controller, you need to start
the fan on hight "5" speed first and then choose a lower speed. A 5-10 seconds is required to allow the DC
fan to respond to the remote each speed.
NOTE: when you change the fan running direction, a 30-40 seconds is required to allow the DC fan to respond
to the remote.
: FAN ON/OFF BUTTON (1):

Press the button to turn the fan on/off.

Press and hold the button for 5 seconds within 30 seconds
of switching the power to the receiver for pairing the
transmitter and receiver.
: LIGHT CONTROL BUTTON (2): Press the button to
turn on/off the light.
～
: FAN SPEED CONTORL BUTTON (3):
Press the speed buttons from 5 to 1, the fan will running at
following order: Extra-high speed (5) → High speed (4)
Medium speed (3) → Low speed (2) → Extra-low speed (1).
: REVERSE FUNCTION BUTTON (4):
button to activate the reverse running function. The fan must be operating to activate the reverse function.
9 | P a g e

USING YOUR CEILING FAN

Press the
Fig. 9
→
Fig. 10