Installation Steps - AVS Aeroskin Instrucciones De Instalación

Installation Steps

Expose 2" (5 cm) of tape liner from each section of Aeroskin. Ensure you can access the free ends of tape liner.
FAR SIDE EDGE
free end
free end
FAR BOTTOM EDGE
3
Center the Aeroskin on the hood.
4
Using the same process, remove tape liner from the driver side
CENTER BOTTOM of hood skin. Repeat for passenger side.
6
Again using the same process, remove tape liner from the driver
side FAR BOTTOM EDGE of hood skin. Repeat for passenger side.
8
NOTE: Actual application may vary slightly from illustrations.
CENTER TOP
free ends
free ends
CENTER BOTTOM
Begin removing remaining tape liner, beginning with the drivers side
CENTER TOP . Grasping the free end, pull tape gently in 6" (15 cm)
sections, while applying even pressure with hand to Aeroskin. Repeat
process for passenger side.
5
NOTE: Do apply pressure closer than 6" (15 cm) to tape
Again using the same process, remove tape liner from the driver
side FAR SIDE EDGE of Aeroskin. Repeat for passenger side.
7
Press firmly along all edges of Aeroskin to ensure adhesion of
9
Page 2 of 3
FAR BOTTOM EDGE
liner as it could accidentally break.
tape to hood surface.
FAR SIDE EDGE
free end
free end