Adjusting The Ridging Shares - Checchi & Magli PLASTIC - STOP PLUS Serie Manual De Uso Y Mantenimiento

Adjusting the ridging shares

The ridging shares are used to cover the edges of the plastic mulch sheet with soil.
- Adjusting the distance of the ploughshares from the edge of the plastic mulch sheet
UN41 0243IH
For adjustments, proceed as outlined below.
1) Use the handwheel (H) to slacken off the spring.
2) Release the spring (B) from the support (F).
3) Loosen the screws (A).
4) Move the arm (C) so that the share is as far away
from the edge of the mulch sheet (D) as stated in
the figure.
5) Tighten the screws (A).
- Adjusting the share pressure on the ground
To adjust the ploughshare pressure, proceed as outlined
below.
1) Turn the handwheel (H) to increase or decrease the
share pressure on the ground.
English language
ADJUSTMENT INFORMATION
10÷15 cm
6) Loosen the screw (E).
7) Move the support (F) and place it in position with
the arm (C).
Check that the stroke limit (G) tallies with the arm.
8) Tighten the screw (E).
9) Attach the spring to the support (F).
10) Use the handwheel (H) to tension the spring.
Repeat the same procedure for the other share.
UN41 0244IH
14
D
Use and maintenance
5
10÷15 cm