Mulch Sheet Laying Procedure - Checchi & Magli PLASTIC - STOP PLUS Serie Manual De Uso Y Mantenimiento

5) Turn the tie rods (A) to adjust the height of the lift
arms (B) (see tractor instruction manual).
6) Insert the pins (C) into the lift arms and fit in the lock
pins (D).
7) Turn the tie rod (E) to adjust the space between the
tie rod and the upper coupling (F) on the support
frame.
If the work vehicle is connected to a planting ma-
chine, position the ball joint (G) in the middle of
the slot (see figure) to offset irregular work vehicle
movements caused by bumpy ground.
8) Insert the pin (H) and the lock pin (L).
9) Remove the safety lock pin (M), slide out pin (N),
and lift the resting foot (P) off the ground.
10) Adjust the tie rod (E) so that the work vehicle is par-
allel with the ground.

Mulch sheet laying procedure

The mulch sheet must be laid on soil which has been
sufficiently crushed and levelled and properly prepared
with a harrow or cultivator.
Do not lay the mulch sheet on ground that is overly
damp.
The version equipped with compacting roller makes the
soil slightly compact and ensures proper mulch sheet
laying.
The version equipped with front support wheels is only
recommended when laying the mulch sheet on carefully
levelled and compacted soils.
To lay the mulch sheet on the ground, proceed as out-
lined below.
1) Position the machine lengthways on the stretch of
ground to cover with the plastic mulch sheet.
2) Unroll the roll (A), following the route of the mulch
sheet, as shown in the figure.
3) Lower the mulch sheet tensioning device (B).
4) Using the tractor's controls, lower the work vehicle to
the ground.
5) With the mulch sheet held on the ground, drive the
work vehicle forwards a few metres.
6) Stop the machine and perform the checks de-
scribed.
- Check that the hoeing shares are properly positioned
(see "Adjusting the hoeing shares").
- Check that the ridging shares are properly positioned
(see "Adjusting the ridging shares").
- Check that the pressure wheels are properly posi-
tioned (see "Adjusting the plastic mulch sheet pres-
sure wheels").
English language
INFORMATION FOR USE
- For unhitching, proceed as outlined below.
1) Select an area with flat, solid ground to park the work
vehicle - tractor.
2) Using the tractor's controls, lower the work vehicle to
the ground.
3) Lower the resting foot (P), insert pin (N) and lock pin
(M).
4) Switch off the tractor engine and remove the ignition
key from the dashboard.
5) Take out the lock pin (L) and remove the pin (H).
6) Slide out the lock pins (D) and remove the lift arms
(B) from the work vehicle's support frame.
UN41 0230 H
- Check that the mulch sheet idle roller is the right
distance off the ground (see "Adjusting the plastic
mulch sheet idle roller").
- Check that the support wheels - if featured - are
properly positioned (see "Adjusting the front support
wheels").
- Check that the mulch sheet is properly tensioned
when unrolling (see "Adjusting the mulch sheet un-
rolling tension").
7) Drive the work vehicle forwards slowly, checking reg-
ularly that the mulch sheet is properly laid; if neces-
sary, make the appropriate corrective measures.
When laying, do not reverse the tractor, as this could
damage the work vehicle.
8) Upon completing a laying stretch, cut the mulch
sheet before beginning a new stretch.
21
6
Use and maintenance