Adjusting The Mulch Sheet Idle Roller; Adjusting The Mulch Sheet Unrolling Tension; Adjusting The Front Support Wheels - Checchi & Magli PLASTIC - STOP PLUS Serie Manual De Uso Y Mantenimiento

Adjusting the mulch sheet idle roller

C
UN41 0259IH

Adjusting the mulch sheet unrolling tension

UN41 0253IH

Adjusting the front support wheels

UN41 0254IH
English language
ADJUSTMENT INFORMATION
B
B
C
A
The idle roller height can be adjusted.
To adjust the idle roller, proceed as outlined below.
1) Loosen the screws (A) on both sides of the machine.
2) Lower the idle roller evenly on both sides and keep
the supports (B) against the guides (C) to ensure
proper mulch sheet unrolling.
3) Tighten the screws (A) on both sides of the machine.
To adjust the mulch sheet unrolling tension, proceed as
outlined below.
1) Release the spring (A) from the tensioning device (B)
and insert it into one of the holes provided.
Information
Adjust the unrolling tension to suit the characteris-
tics of the mulch sheet used and weather conditions
(hot, cold, etc.).
The support wheels are used to support the work vehicle
and keep it horizontal during work.
The support wheels are mounted on the work vehicle as
an alternative to the compacting roller.
To adjust the support wheels, proceed as outlined be-
low.
1) Lower the feet (A) to prop up the machine.
2) Unscrew the screws (D) and position the work vehi-
cle's support wheel aligned with the tractor's wheels.
3) Tighten the screws (D).
4) Unscrew the screws (B) until the wheel is released.
5) Raise or lower the wheel as required.
6) Choose the knockouts on the support (C) near the re-
quired height and tighten the screws (B) aligned with
the holes.
- Repeat the same procedure for the other wheel.
- Position the support wheels so that the mulch sheet
idle roller is at least 10-15 cm away from the ground
during work.
7) Lift the feet (A) off the ground.
19
5
Use and maintenance