Kit For Rear 3-Point Hitching - Checchi & Magli PLASTIC - STOP PLUS Serie Manual De Uso Y Mantenimiento

Optional accessories
This section outlines the installation and features of cer-
tain accessories that can be supplied after delivery of the
machine.
To ensure the safety of personnel, carefully read and fol-
low the safety instructions given in section "3", as well as
applicable safety in the workplace laws.

Kit for rear 3-point hitching

The rear three-point hitch is suitable for coupling the
work vehicle to WOLF/1 and WOLF/2 planting ma-
chines.
UN41 0258IH
To assemble the support structure, proceed as outlined
below.
1) Lower the structure onto the work vehicle.
2) Fit the tie rod (G)
3) Insert the pins (A).
4) Insert the washers (B).
5) Tighten the nuts (C).
6) Insert the screws (D).
7) Insert the washers (E).
8) Tighten the nuts (F).
9) Position the planting machine supports (M) on the
centre line of the machine.
English language
G
U
S
ENCLOSURES
Danger - Warning
Dismantling and assembly operations must be car-
ried out using suitable tools, by authorised person-
nel with the necessary skills required for the job in
hand.
Take all the precautions required to work safely.
Danger - Warning
Only ever couple the mulching machine to the plant-
ing machines envisaged by the manufacturer (see
"Technical specifications - Planting machines that
can be coupled to the machine").
R
10) Secure the supports to the machine with the U-
bolts (T) and nuts (Q) supplied with the rear 3-point
hitch.
11) Unscrew the screws (Z) and remove the plate (V)
from both supports.
12) Lift the planting machine and insert the pins (P) in
the supports (M).
13) Position the plate (V) and tighten the screws (Z) on
both supports.
14) Fit the tie rod (R) as shown in the figure.
15) Insert the pins (S) and secure them with their lock
pins (U).
16) Adjust the tie rod (R) to position the planting ma-
chine horizontal to the ground.
29
A
S
U
M
Use and maintenance