Irrigation Hosepipe - Checchi & Magli PLASTIC - STOP PLUS Serie Manual De Uso Y Mantenimiento

Irrigation hosepipe

The hosepipe is used to allow greater control when ir-
rigating seedlings and also to spread fertilisers dissolved
in water (fertigation).
UN41 0260FM
- Fitting the irrigation hosepipe holder
To fit the hosepipe, proceed as outlined below.
1) Position the hosepipe on the work vehicle.
2) Fit the U-bolts (A).
3) Tighten the nuts (B).
English language
ENCLOSURES
The hosepipe is usually placed underneath the plastic
mulch sheet, in the centre.
E
D
- Irrigation hosepipe reel housing and routing
1) Loosen the locking levers (C).
2) Remove the disk (D).
3) Fit the hosepipe onto the shaft (E).
4) Fit the disk (D) onto the shaft and tighten the locking
levers (C).
5) Unwind the hosepipe, following the route shown in
the figure.
6) Turn the nut (F), as required, to adjust the tension of
the irrigation hosepipe.
32
A
Use and maintenance