Chapter 4 Unpacking, Installation And System Check; Overview; Unpacking; Installation - DePuy Synthes Purevue Manual De Instrucciones

Chapter 4
Unpacking, Installation and System Check
4.1

Overview

This section describes how to unpack the Camera Control System and connect the accessories .
After unpacking and assembly, follow the system check procedure (Section 4 .7) to ensure that
the Camera Control System is working properly .
4.2

Unpacking

1 . Place hands in the open areas between the two pieces of packaging material on both
sides of the console until you can securely grasp the underside of the unit .
2 . Carefully remove the unit from the box and place it on a level and sturdy surface .
3 . Verify that all items on the packing list match the products you have received .
4 . Report damage immediately to a DePuy Synthes Sales Representative or call
DePuy Synthes Customer Service in the USA at +1 (800) 382-4682 . Save all packing
materials to use in the event you must return product(s) to DePuy Synthes . Outside the
United States, contact your local affiliate .
CAUTION! Do not drop the device. Damage may result.
4.3

Installation

Install the Camera Control System outside of the sterile field and in a location where there
enough space to access the controls . Position the unit so that access to power main is not
obstructed . The System may be installed on the video cart (Ref . 242283, 242287) or on a level
surface outside of the sterile field . Refer to Figure 3, Installation .
1 2
1 . Connect the power .
a . Connect the female end of the power cable (included) to the male connector on the
Camera Control System (7) .
3
3
4
1 2
Figure 3. Installation
17
5
6
7
8