Troubleshooting; Corrective Action - Harbor Breeze RLC52WW5C1R Manual Del Usuario

TROUBLESHOOTING

WARNING: Before beginning work, shut off the power supply to avoid electrical shock.
PROBLEM
Fan does not
move.
Noisy operation.
Excessive
wobbling.
Fan operates but
light fails.
POSSIBLE CAUSE
1. Reverse switch not engaged.
2. Power is off or fuse is blown.
3. Faulty wire connection.
4. Wires in light kit fitter not wired
correctly.
5. Learning code process between fan
and remote control transmitter (O)
may not have been successful and
learning code was not activated.
1. Blades are loose.
2. Cracked blade.
3. Full range dimmer switch.
4. Fan is new.
5. Motor housing is loose.
1. Blades are loose.
2. Blade arms incorrectly attached.
3. Unbalanced blades.
4. Fan not securely mounted.
1. Bulb(s) not installed correctly.
2. Wires in outlet box not wired
properly.
3. Wall switch to light is off.
4. Wires in light kit fitter not wired
correctly.

CORRECTIVE ACTION

1. Push switch firmly either left or
right.
2. Turn power on or check fuse.
3. Turn power off. Loosen motor
housing and check all
connections.
4. Check that male and female plugs
in fitter plate are connected
properly according to instructions
on page 10.
5. Turn off power and repeat
instructions in Step 2 on page 13.
1. Tighten all blade screws.
2. Replace blade.
3. Replace with an approved speed
control device.
4. Allow fan a "break in" period of a
few days, especially when running
the fan at Medium and High
speeds.
5. Verify mounting bracket is secure
according to instructions on page
8.
1. Tighten all blade screws.
2. Re-install blade arms.
3. Switch one blade with a blade
from the opposite side.
4. Verify mounting bracket is secure.
1. Re-install bulb(s).
2. Check wires in outlet box and, if
necessary, re-wire according to
instructions on page 7.
3. Make sure wall switch to light is
on.
4. Check that molex connections in
light kit fitter are connected
properly according to instructions
on page 10.
Lowes.com/harborbreeze
16