Harbor Breeze RLC52WW5C1R Manual Del Usuario página 9

FINAL INSTALLATION
3. Noting the THIS SIDE UP label on blade (G), align
posts in blade plate (I) with holes on bottom of blade
(G). Then align holes in blade arm (H) with holes on
top of blade (G), and push up on blade plate (I) until
posts go through the holes in blade arm (H).
Partially insert three blade screws (AA) along with
three blade washers (DD) to secure the blade plate
(I) and blade arm (H) to the blade (G). Then, tighten
each blade screw (AA), starting with the one in the
middle. Repeat for remaining blades (G).
Hardware Used
Blade Screw
AA
Blade Washer
DD
Attach blade arms (H) to the bottom of motor
4.
assembly (E) with motor screws (J) and lock
washers (K) previously removed (Step 4, page 6).
Tighten motor screws (J) securely.
Note: Make sure to completely secure each blade
arm (H) before proceeding to the next.
5. Remove one motor plate screw (Q) from motor
plate located at bottom of motor assembly (E) and
loosen the other two motor plate screws (Q). Align
slotted holes in middle of fitter plate (T) with
loosened motor plate screws (Q), allowing male
plug from motor assembly (E) to come through hole
in middle of fitter plate (T). Twist fitter plate (T) to
lock in place. Re-insert motor plate screw (Q) that
was just removed, and then tighten all three motor
plate screws (Q) securely.
3
H
I
x 15
x 15
3 4
5
E
T
Male Plug
9
AA
E
H
K
J
J
Q
Lowes.com/harborbreeze
G
F
Motor
Plate
Q