Aa Motor Screw (10 In Motor; 1 In Hardware Pack); Cc 5.4M/M Lock Washer - Harbor Breeze PEH44BCW5MC Manual Del Usuario

INITIAL INSTALLATION
3. Locate motor assembly mounting screws
(FF) on underside of mounting plate (B).
Remove the motor assembly mounting screw
(FF) with a red dot, along with the lock
washer (GG)--save for later use. Partially
loosen the other two motor assembly
mounting screws (FF). (Fig. 3)
4. Secure mounting plate (B) to outlet box
using screws, spring washers, and flat
washers provided with the outlet box. (Fig. 4)
Pull wires from outlet box through center hole
in mounting plate (B).
*Note: It is very important that you use the
proper hardware when installing the
mounting plate (B) as this will support the
fan.
5. Remove motor screws (AA) and lock
washers (CC) from underside of motor--save
to attach blade arms (G) later on. If there are
also plastic motor blocks, discard them at
this time. (Fig. 5)
6. Use the square hole in the plate at the top
of the motor assembly (D) and slide it over
the "J" hook on the mounting plate (B) to
support the fan during wiring. (Fig. 6)
Hint: Place square hole in motor assembly
(D) over "J" hook in mounting plate (B). While
keeping the motor assembly (D) flush with
the mounting plate (B), slide motor assembly
(D) onto "J" hook.
GG
FF
Red Dot
Hardware Used
Motor Assembly
FF
Mounting Screw
GG
Lock Washer
B
D
Hardware Used
Motor Screw
AA
CC
5.4 M/M Lock Washer
B
Square Hole
D
7
Fig. 3
B
GG
FF
x 3
x 3
Fig. 4
Fig. 5
Motor
CC
AA
x 10
x 10
Fig. 6
"J" Hook