Final Installation - Harbor Breeze PEH44BCW5MC Manual Del Usuario

WIRING
2. Wrap electrical tape around each wire connector
(EE) down to the wire as shown in Fig. 2.
Warning: Make sure no bare wire or wire
strands are visible after making connections. Place
green and white connections on opposite side of box
from the black and blue (if applicable) connections.
Turn spliced/taped wires upward and gently push
wires and wire connectors (EE) into outlet box.
IMPORTANT: Using a full range dimmer switch to
control fan speed will cause a loud humming noise
from fan. To reduce the risk of fire or electric shock,
do NOT use a full range dimmer switch to control fan
speed. (Fig. 3)

FINAL INSTALLATION

1. Gently swing motor assembly (D) up to mounting
plate (B), allowing slotted holes on plate at top of
motor assembly (D) to align with loosened motor
assembly mounting screws (FF) in mounting plate
(B). Twist motor assembly (D) to lock. Re-insert
motor assembly mounting screw (FF), along with
lock washer (GG), that was previously removed
(Step 3, page 7). Tighten all three motor assembly
mounting screws (FF) securely. (Fig. 1)
EE
Hardware Used
E3 Wire Connector
EE
For illustrative purposes only--not
intended to cover all types of controls
GG
Hardware Used
Motor Assembly
FF
Mounting Screw
GG
Lock Washer
9
Fig. 2
EE
EE N
Fig. 3
3
2
1
Dimmer
Speed
Switch
Switch
Fig. 1
FF
D
x 4
B
x 3
x 3