Honda Motor EU65is Manual De Instrucciones página 374

cap.12 EU65is 6500is 07.12.17 5:04 PM ページ12-2
• FLYWHEEL REMOVAL
1) Holding the flywheel with the crank pulley holder, 47 mm
loosen the 16 mm special nut.
TOOL:
Crank pulley holder, 47 mm
2) Remove the flywheel using the flywheel puller.
TOOL:
Flywheel puller
• FLYWHEEL INSTALLATION
1) Clean off oil or grease from the taper of the crankshaft and
tapered hole in the flywheel.
Install the woodruff key on the crankshaft and then install
the flywheel.
2) Apply oil to the threads of the 16 mm special nut.
Holding the flywheel with the crank pulley holder, 47 mm
tighten the 16 mm special nut.
TORQUE: 113 N . m (11.5 kgf . m, 83 lbf . ft)
TOOL:
Crank pulley holder, 47 mm
12-2
[1]
CRANK PULLEY
HOLDER, 47 mm
07925-6570000
07925-6570000
07935-8050004
[1]
WOODRUFF KEY
[2]
FLYWHEEL
07925-6570000
[1]
FLYWHEEL PULLER
07935-8050004
[1]
CRANK PULLEY
HOLDER, 47 mm
07925-6570000