Harbor Breeze TILGHMAN Manual Del Usuario página 14

Ocultar thumbs Ver también para TILGHMAN:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FINAL INSTALLATION
2.
Align posts in blade plate (V) with holes on one
side of blade (G). Align holes in blade arm (H) with
holes on opposite side of blade (G) and then push
up on blade plate (V) until posts go through holes
in blade arm (H). Use three blade screws (AA) and
three blade washers (BB) to secure blade plate (V)
and blade arm (H) to blade (G). Do not tighten
blade screws (AA) until each blade screw (AA) has
been started, and then tighten each blade screw
(AA), starting with the one in the middle. (Fig. 2)
Repeat with remaining blades (G).
Hardware Used
Blade Screw
AA
BB
Blade Washer
Locate motor screws (J) and lock washers (K) that
3.
were removed in Step 5 on page 7.
Insert two motor screws (J), along with lock washers
(K), through one blade arm (H) to attach blade arm
(H) to motor. Tighten motor screws (J) securely.
(Fig. 3) Repeat with remaining blade arms (J),
making sure to completely secure each blade arm
(J) before proceeding with the next.
If you wish to USE the light kit, remove three
4.
switch housing plate screws (W) from underside of
motor. (Fig. 4)
Punch center cap out of switch housing (F) with a
screwdriver. Locate BLUE (or BLACK) and
WHITE wires in switch housing (F) labeled FOR
LIGHT and remove and discard plastic that holds
these two wires together. (Fig. 4)
If you do NOT wish to use the light kit, please
go to section titled "Installing Fan Without Included
Light Kit (Optional)" on page 17.
2
H
x15
x15
3
4
Center Cap
14
AA
BB
V
K
J
Switch
W
Housing Plate
G
H
D
F

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

E-wck44abz5lks

Tabla de contenido