Closemount Style Fan Mounting - Harbor Breeze TILGHMAN Manual Del Usuario

DOWNROD STYLE FAN MOUNTING
5. If you decided to cut back the lead wires in Step 4,
strip 1/2 in. of insulation from end of white wire.
Twist stripped ends of each strand of wire within
the insulation with pliers (not included). (Fig. 5)
Repeat Step 5 for black, blue (if applicable) and
green wires.
6. Install ball end of downrod (A) into mounting
bracket (C) opening. Align slot in ball with tab in
mounting bracket (C). (Fig. 6)
DANGER: Failure to align slot in ball with tab
may result in serious injury or death.
Continue to "Wiring" instructions on page 11.

CLOSEMOUNT STYLE FAN MOUNTING

1.
Remove canopy cover from bottom of canopy (B).
(Fig. 1) [Note: It may be necessary to use the
handle end of a screwdriver (not included) to
remove the canopy cover by tapping on the
canopy cover from the inside of the canopy (B).]
*Helpful Hint: Closemount style mounting is
more suitable for ceilings lower than 8 ft. (2.44 m)
high. The downrod (A), yoke cover (E), hanging
ball, and canopy cover are not used in this type of
installation.
5
6
A
1
9
C
Tab
Slot
B
B
Canopy
Cover