Important; Downrod Style Fan Mounting - Harbor Breeze TILGHMAN Manual Del Usuario

INITIAL INSTALLATION
Loosen canopy mounting screws (L) in slotted holes
4.
in canopy (B) and remove the other two canopy
mounting screws (L)--save canopy mounting screws
(L) for later use. Remove mounting bracket (C) from
canopy (B). (Fig. 4A)
Secure mounting bracket (C) to outlet box using
screws, spring washers, and flat washers provided
with the outlet box. (Fig. 4B)
*Note: It is very important that you use the proper
hardware when installing the mounting bracket (C) as
this will support the fan.
IMPORTANT: If using the angle mount, make sure
open end of mounting bracket (C) is installed facing
the higher point of the ceiling.
5. Remove motor screws (J) and lock washers (K) from
underside of motor and save for blade arm (H)
attachment later on. [If there are plastic motor blocks
installed with the motor screws (J) and lock washers
(K), discard the plastic motor blocks.] (Fig. 5)
Follow mounting instructions on pages 7 - 9 for
"Downrod Style Fan Mounting" or proceed to pages 9
and 10 for "Closemount Style Fan Mounting,"
depending on mounting method (A or B) chosen in
Step 2 on previous page.

DOWNROD STYLE FAN MOUNTING

1.
Remove pin (M) and clip (N) from downrod (A).
(Fig. 1A)
Partially loosen set screws in motor housing yoke
at top of motor housing (D). (Fig. 1B)
*Helpful Hint: Downrod style mounting is best
suited for ceilings 8 ft. (2.44 m) high or higher. For
taller ceilings you may want to use a longer
downrod (not included) than the one provided.
Angle style mounting is best suited for angled or
vaulted ceilings. A longer downrod is sometimes
necessary to ensure proper blade clearance.
4A
C
L
5
2 1A
A
N
7
4B
L
C
B
J
K
1B
Set
Screw
M
D