Washing And Sanitizing The Components; Reassembling The Washed Components - horeca Granitore 1 Manual De Empleo

Fig.35
3 remove the bowl from its seat by pushing and tapping lightly on the rear
Fig.36
4 take out the auger and remove the seals (A and B).
Fig.37
- 16 _EN -
CLICK

7.4. Washing and sanitizing the components

All of the previously disassembled and removed components must be thor-
oughly washed and sanitized.
Important: the sanitizing solution must comply with the regula-
tions in force at the time the machine is used.
To carry out the procedure correctly, please use the following instructions:
1. Fill a container with a sanitizer solution mixed in water (2% of sodium hy-
poclorite mixed in water)
2. Thoroughly wash the tank, lid and evaporator with a sponge soaked in the
sanitizer solution
3. Thoroughly wash again with clean water
4. Fill another container with a sanitizer solution
5. Dip the dismantled components into the sanitizer solution
6. Leave the dismantled components to soak in the solution for 30 minutes
7. Thoroughly wash again with clean water
8. Place the components on a clean surface and dry them
9. Assemble the machine as described in part 7.5
10. Before using the machine again carry out the rinsing cycle with clean water
( part 7.6 ).
Warning: do not submerge lids equipped with lighting in any
type of liquid. Before starting the cleaning and sanitising opera-
tions of the lid, remove it from the machine as described in the
previous chapter.
It is forbidden to wash and/or sanitise the lid while it is installed
in the machine.

7.5. Reassembling the washed components

All of the washed and sanitized components must be carefully reassembled.
Some components must be adequately lubricated in order to ensure that they
Apply the seal (A) on the auger as shown in the g.38.
Fig.38
SL310006542 Ed.02 - 07-2017