Cpr; Skin Care; Incontinence / Drainage; General Operation - Getinge Arjohuntleigh AtmosAir 9000A Instrucciones De Uso

CPR

1. Level bed.
2. Disconnect hoses from pump to level mattress, as
shown at right (Figure 4).
3. Lower or remove side rail on caregiver's side if
necessary.
4. Begin CPR as per facility protocol. Consider use of
backboard if indicated.
5. After CPR is performed:
• Remove backboard if used.
• Reconnect pump hoses to mattress.
• Raise or install side rail as necessary.
• Reconfigure bed and accessories as in initial
placement.

Skin Care

• Remove excess moisture and keep skin dry and clean.
• Check patient's skin regularly, particularly in areas where incontinence and
drainage occur.
• Ensure linens under patient are not wrinkled.

Incontinence / Drainage

• Use moisture-impermeable underpads for incontinent patients.
• Wipe surface clean and replace bed linens as required (see Care and Cleaning).

General Operation

Avoid contact of sharp instruments with the AtmosAir MRS.
Punctures, cuts and tears may prevent proper inflation and
air pressure maintenance.

Transport Mode

When disconnected from the pump, the AtmosAir 9000A MRS will operate as a reactive
surface with the full operation of the SAT system. For transport, there are two options:
1. Disconnect the tube assembly from the mattress. Valves will close off as soon as the
tube assembly is disconnected.
2. Disconnect the tube assembly from the pump and securely place the transport cap
on the tube assembly to maintain a seal.
8
Figure 4 Disconnect Hoses
Figure 5 Avoid Sharp Instruments