Cleaning Atmosair Pump And Tubes; Preventive Maintenance Schedule; Daily Cleaning; Weekly Cleaning - Getinge Arjohuntleigh AtmosAir 9000A Instrucciones De Uso

Cleaning AtmosAir Pump and Tubes

1. Ensure pump is unplugged.
2. Wipe surface of pump and tubes with coarse cloth using an approved disinfectant
germicide mixed to manufacturer's instructions. Do not flood any part of the
pump with cleaning solution.
Avoid spilling fluids on pump controls. If spills do occur, clean fluid
from pump wearing rubber gloves or while unit is unplugged to avoid
any possibility of shock. Once fluid is removed, check operation of
components in area of spill. Fluids remaining on controls can cause
corrosion, which may cause components to fail or operate erratically,
possibly producing potential hazards for patient and staff.
3. Wipe off excess solution.
4. Disinfect pump and tubes with a chlorine solution (mixed according to the
instructions in the Care and Cleaning section). Using a clean cloth, wring out excess
solution until cloth is damp. Wipe pump surface and tubes with damp cloth.
5. Allow to air dry.

Preventive Maintenance Schedule

Preventive maintenance for the AtmosAir MRS consists of regular cleaning (see Care and
Cleaning) and an overall system check-out to be performed at the intervals described below.
All components must be cleaned, disinfected and inspected after each patient's use
and before use by a new patient. Always use standard precautions, treating all used
equipment as contaminated. Institutions should follow local protocols for cleaning and
disinfection.

Daily Cleaning

The cover should be wiped daily with a mild soap and water solution.

Weekly Cleaning

The pump and hoses should be cleaned weekly.

Inspection / System Checks

Check each of the following before placing the AtmosAir MRS with a new patient:
1. Check mattress surface for tears or cracking; do not use if tears or cracks are present.
2. Ensure mattress is free of stains and is not overly faded.
3. Ensure air inlet hoses and connectors on mattress and pump are clean and
undamaged.
4. Ensure pump and power cord are clean and undamaged.
5. Ensure pump hanger brackets are secure and operate correctly.
6. Ensure power switch and comfort control knob operate correctly.
7. Attach pump to the hoses and power on to ensure there are no air leaks.
10