Publicidad
Using SnüzPod in Bedside
Mode (fastened to bed)
When attached to your bed, SnüzPod⁴ has a permanent half-height wall
to meet the new bedside crib standard BS EN 1130:2019.
Follow the instructions below to fit the straps to your
1
bed - these will be tightened later.
Use the attachment system provided. Do not use another attachment system.
Frame style bed
Divan or solid bed base
18
Remove the metal pole from the zip down wall.
2
Leaving the pole in situ could be hazardous.
Always retain the metal pole in the rear wall (the wall furthest away from your bed).
Release velcro tabs and lower the zips fully.
3
Fold the zip down wall down, tucking it in between
the crib frame and the adult mattress.
Ensure that your mattress is level with the top
4
of the zip down wall of the SnüzPod⁴.
PSP4015
r
Part: PSP4015
PSP4016
Tighten straps to secure the SnüzPod⁴ to your bed.
s
5
Ensure that the bassinet sits fully down on the stand and is not resting on any part of the
parents' bed.
Part: PSP4016
Do not over tighten the strap, as this may cause the stand to tilt. Ensure that the stand is
flush with your bed frame / base.
Check the tightness of the attachment system before each use by pulling the bedside sleeper
in a direction away from the adult bed.
Tuck any excess strap under your bed base, away from babies and children.
WARNING:
WARNING:
etc. do not enter or cover the inside of the crib.
Ensure there are no gaps between the SnüzPod and the adult's bed.
During use, always ensure that the parents' bedding, sheets, blankets
19
Publicidad
