General Information; General Details; Ownership Of The Information; Contents Of The Assembly Instructions - Rivacold CO2NNEXT Instrucciones Para El Ensamblaje

1. General Information

EN

General details

These assembly instructions are an integral part of Co2Nnext (which is identified in this document
with the term partly completed machinery) manufactured by company; for this reason, they must
be part of the technical file of the final machine into which this partly completed machinery will be
incorporated.
These instructions have been prepared with the purpose of providing to the technicians appointed
to installation and maintenance of the partly completed machinery the information and instructions
that are essential to properly operate in safe conditions.
CAUTION: because they must be easily and readily available to be consulted, these
instructions must be kept in a known and accessible place.
NOTE: The Purchaser can request copy of this document (for example, in case the
original gets damaged) in written form to the Technical Office of the Manufacturer
(see Paragraph 1.7.1 – Request for Assistance in this Chapter on the matter),
undertaking commitment, at any rate, to return the damaged copy.

Ownership of the Information

The ownership of the information contained in these instructions is reserved.
All rights are reserved.
These instructions cannot be reproduced or photocopied, in whole or in part, without prior written
consent by the Manufacturer. The use of these set of documents is only allowed to the customer to
whom the instructions are supplied along with the partly completed machinery and only for the
purpose of installing and carrying out maintenance on the partly completed machinery to which
the instructions refer.
The Manufacturer declares that the information contained in these instructions are congruent with
the technical and safety-related specifications of the partly completed machinery to which the
instructions refer. The drawings, diagrams, and technical data reported herein are updated to the
date in which this document was published, and are exclusively valid for the partly complete
machinery to which they have been annexed.
The Manufacturer reserves itself the right to make changes or improvements to this set of
documents without fore-notice.
The Manufacturer does not accept any responsibility for direct or indirect damages to persons,
things, or domestic animals that ensue from a use made of these documents or of the partly
completed machinery in conditions other than those prescribed.

Contents of the assembly instructions

These assembly instructions are addressed to the technicians, so that they may know and properly
install the partly completed machinery.
In fact, these instructions include, in addition to a description of the partly completed machinery,
instructions and indications for:
 correct transport and installation of the partly completed machinery;
 proper cleaning, adjustments, and maintenance of the partly completed machinery;
 pay attention to the most basic safety and anti-injury rules.
It is necessary to carefully read all the chapters to understand the indications provided in these
instructions and to operate with the partly completed machinery; for a future and smoother search
of the contents, please refer to the Chart 1, which contains a description of the topics discussed in
the chapters.
38 / 168
Co2Nnext rev.00