Convenient Functions; Creating Tones With Ease (Ez Tone); Checking The Values Of Controls - Boss ME-70 El Manual Del Propietario

Convenient Functions

Creating Tones with Ease (EZ Tone)

EZ Tone is a feature for creating sounds quickly and easily by calling up saved parameter settings for each individual effect type.
The ME-70 comes from the factory with optimal settings for each effect type saved as EZ Tones. If you like, you can edit an EZ Tone and save
your changes over the factory setting. This allows you to use EZ Tone to quickly call up your favorite settings for each effect type.
Choosing (Calling Up) an EZ Tone
When EZ TONE is on, you call up the saved settings for an effect with
its TYPE knob.
2
Saving the Created Tone as an EZ Tone
If you edit an EZ Tone with an effect's controls, you can save the
changes.

Checking the Values of Controls

Operations such as calling up patches or EZ Tones may result in
discrepancies between the set parameters and the positions shown
by the controls.
You can get the actual parameter values to appear in the display so
you can check them.
E-12
1
1 3 2
1.
Press [EZ TONE].
The EZ TONE indicator lights.
You can use the number pedals to switch the effects on and off, allowing you to
check each effect's sound by itself.
To switch off PREAMP, use the TYPE knob to select OFF.
2.
Use an effect's TYPE knob to choose its EZ Tone.
Optimal effect parameters for the chosen TYPE value are set
automatically.
After you choose an EZ Tone, you can use the effect's controls to fine-tune the
sound as desired.
1.
Hold down [EZ TONE] and press [WRITE].
The indicator for the save-destination effect flashes.
Pressing only [WRITE] commences the procedure for saving the current settings
for all effects as a patch.
2.
Use BANK [ ] and [
want to save.
The selection cycles through the choices in this sequence, with the
current choice flashing: COMP/FX
PREAMP all effects COMP/FX
When you select "all effects," you're saving the EZ Tones for every effect.
3.
Press [WRITE].
The edited EZ Tone is stored in memory at the location now selected by
the TYPE knob.
Performing a save operation causes any previous EZ Tone already saved at the
TYPE destination to be lost.
1.
Hold down [EDIT/EXIT] and turn the control for the
value you want to check.
The value of the control appears in the display for a brief time.
] to choose the effect you
OD/DS MODULATION DELAY
...