Creating Sounds - Boss ME-70 El Manual Del Propietario

Creating Sounds

AUX INGUITAR
Making the Connections and Turning the Power On
Turn down the
volume all the way
on all equipment!
Electric Guitar
The battery compartment is located on the underside.
Insert the included batteries, taking care to orient them correctly.
When turning the unit upside-down, get a bunch of newspapers or magazines, and place them under
the four corners or at both ends to prevent damage to the buttons and controls. Also, you should try to
orient the unit so no buttons or controls get damaged.
When turning the unit upside-down, handle with care to avoid dropping it, or allowing it to fall or tip over.
Carefully follow the installation instructions for batteries, and make sure you observe the correct polarity.
Avoid using new batteries together with used ones. In addition, avoid mixing different types of batteries.
Remove the batteries whenever the unit is to remain unused for an extended period of time.
If a battery has leaked, use a soft piece of cloth or paper towel to wipe all remnants of the discharge
from the battery compartment. Then install new batteries. To avoid inflammation of the skin, make sure
that none of the battery discharge gets onto your hands or skin. Exercise the utmost caution so that
none of the discharge gets near your eyes. Immediately rinse the affected area with running water if
any of the discharge has entered the eyes.
Never keep batteries together with metallic objects such as ballpoint pens, necklaces, hairpins, etc.
Expected battery life under continuous use: Carbon: 5 hours, Alkaline: 13 hours
These figures will vary depending on the actual conditions of use.
When operating on battery power only, the unit's indicator will become dim when battery power gets too low.
Replace the battery as soon as possible.
We recommend that you keep batteries installed in the unit even when you're powering it with the AC adaptor.
That way, you'll be able to continue a performance even if the cord of the AC adaptor gets accidently disconnected from the unit.
Note when connecting the ME-70 to the other devices
Once the connections have been completed, turn on power to your various devices in
the order specified. By turning on devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
To prevent malfunction and/or damage to speakers or other devices, always turn down the
volume, and turn off the power on all devices before making any connections.
Raise the amp volume only after turning on the power to all connected devices.
This unit is equipped with a protection circuit. A brief interval (a few seconds) after power up is
required before the unit will operate normally.
When connection cables with resistors are used, the volume level of equipment connected to
the inputs (AUX IN) may be low. If this happens, use connection cables that do not contain resistors.
E-2
Guitar Amp
Connect the
equipment.
Insert the plug
to power up the
ME-70.
Digital Audio
Player, etc.
Switch on the
amp's power last!
The ME-70 has no built-in amp or speakers. To hear sounds,
you'll need to provide a guitar amplifier, stereo headphones,
or other such equipment.
For mono output, connect the cable to just the L/MONO jack.
To send the output from the REC OUT/PHONES jack to a
recorder or the like, use a special cable (PCS-31L; sold separately).
If you use an ordinary guitar cable, only the left-channel audio is
output.
Footswitch
(BOSS FS-6, etc.)
You can mix stereo
audio from AUX IN
with the output.
Stereo Headphones