Storz AUTOCON II 400 Manual De Servicio página 138

118
Anhang
Hinweise zur elektromagnetischen
Verträglichkeit (EMV)
Guidance and manufacturer's declaration – electromagnetic immunity
®
AUTOCON ll 400 model 20 5352 20-11x is intended for use in the electromagnetic environment specified below. The customer or user of the
®
AUTOCON ll 400 model 20 5352 20-11x should ensure that it is used in such an environment.
Immunity test EN/IEC 60601 test level
Electrostatic Discharge (ESD) ± 6 kV contact
IEC 61000-4-2 ± 8 kV air
Electrical fast ± 2 kV for power supply lines
transient/burst ± 1 kV for input/output lines
IEC 61000-4-4
Surge ± 1 kV differential mode
IEC 61000-4-5 ± 2 kV common mode
Voltage dips, short
interruptions and voltage <5% U
variations on power supply (>95% dip in U
input lines for 0.5 cycle
IEC 61000-4-11
40% U
(60% dip in U
for 5 cycles
70% U
(30% dip in U
for 25 cycles
<5% U
(>95% dip in U
for 5 sec
Power frequency
(50/60 Hz) 3 A/m
magnetic field
IEC 61000-4-8
* Note: U is the a.c. mains voltage prior to application of the test level.
T
Appendix
Electromagnetic Compatibility (EMC)
Information
Table 202
Compliance level
Complies
± 6 kV contact
± 8 kV air
Complies
± 2 kV for power supply
lines
± 1 kV for input/output lines
Complies
± 1 kV differential mode
± 2 kV common mode
Complies
* <5% U *
T T
) (>95% dip in U
T T
for 0.5 cycle
Complies
40% U
T T
) (60% dip in U )
T T
for 5 cycles
Complies
70% U
T T
) (30% dip in U )
T T
for 25 cycles
Complies
<5% U
T T
) (>95% dip in U
T T
for 5 sec
Complies
3 A/m
Anexo
Indicaciones sobre compatibilidad
electromagnética (CEM)
Electromagnetic environment - guidance
Floors should be wood, concrete or ceramic tile. If
floors are covered with synthetic material, the relative
humidity should be at least 30%.
Mains power quality should be that of a typical
commercial or hospital environment. If image
distortion occurs it may be necessary to further filter
the power quality by using a AC line filter.
Mains power quality should be that of a typical
commercial or hospital environment.
Mains power quality should be that of a typical
commercial or hospital environment.
)
If the user of the equipment or system requires
continued operation during power mains interruptions,
it is recommended that the equipment or system be
powered from an uninterruptible power supply or a
battery.
)
Power frequency magnetic fields should be at levels
characteristic of a typical location in a typical
commercial or hospital environment.