Multiflo Cable Adapter - Brooks Instrument GF40 Serie Manual De Instalación Y Funcionamiento

Installation and Operation Manual
X-TMF-GF40-GF80-Series-MFC-eng
Part Number: 541B161AAG
August, 2012
778Z011ZZZ Basic MultiFlo Configurator Kit
w/Power Supply and Adapter Cables
A331710003 Cable Assembly 2.5mm
A332300001 Converter 232/485
Connect the MultiFlo cable adapter 2.5-mm jack to the diagnostic port on the
top of the device. See Figure 2-7.
Connect the RS485 end of the converter to the 15-pin RS485 end of the

MultiFlo Cable Adapter.

Connect the RS-232 end of the converter to the Serial Port of a laptop or PC.
The latest MutliFlo Configurator Software and Databases and MultiFlo
Configurator Quick Start Guide are available on the Brooks Instrument
website at: www.BrooksInstrument.com/MultiFlo. Please reference the
MultiFlo Configurator Quick Start Guide for installation and operation details.
Download the MultiFlo Configurator software into your computer from the
Brooks Instrument website www.BrooksInstrument.com/MultiFlo. Install the
MultiFlo Configurator as described in the MultiFlo Configurator Quick Start
Guide and use the guide as a reference for operation details.
DO NOT make any connections to unlabeled connector pins.
Any failure to comply could damage the GF40/GF80 Series and/or
the mating electrical device. Before connecting the cable, make
sure that all pin connections of the mating cable have the same
pin out connections. When installing and removing cables to
and from your computer, make sure the power is turned off
on your computer. This will prevent damage to your computer
and associated equipment.
Figure 2-6 RS232/RS485 Converter (P/N 332300001)
Section 2 Installation
®
Brooks GF40/GF80 Series
2-11