Connect Tool To Compressed Air Supply - Prebena PKT-2-J50 SD Manual De Instrucciones Original

Preparing the tool

Connect tool to compressed air supply

You can connect the tool to a compressed air system or to a
compressed air cartridge.
If you connect the tool to a compressed air system by means of an
adapter, you can carry out frequent brad driving operations efficiently
in the same place. In addition you can supply oil to the tool via the
compressed air system.
If you connect the tool to a compressed air cartridge, you are
independent of a stationary installation.
The admissible working pressure of the tool is 10 bar. If the
admissible working pressure is exceeded, the pointer of the pressure
gauge for the working pressure moves into the red range.
This can occur under the following conditions:
 If both safety valves are defective,
 If you have set the working pressure too high (see page 33), or
 If you have connected the tool to a compressed air system with
excessively high pressure or to an unsuitable compressed air
cartridge.
18
WARNING
Risk of explosion if the maximum working
pressure is exceeded.
 In this case immediately disconnect the
compressed air supply from the tool (see
page 40).