Anest Iwata DDP 120 B.TE Manual De Instrucciones página 7

EN DPS-120 C - DPS-90 G
7.4 INSTALLATION OF DPS MODELS
1
A - STAND TYPE AND CART TYPE
1. Remove the dust proof caps (B,E,F,H,I on page 15)
2. Detach the pump assembly from the support by removing Hex. Bolts (M8).
3. Flip the stand and assemble the pump assy to the right position.
Stand
Pump
Hex. Bolt (M8)
2
PAINT SUPPLY / SUCTION HOSE
1. Connect the suction hose to the paint inlet joint (H page 15).
2. Fix the drain hose to the suction hose with band (3 spots wherever you want).
B
TANK MOUNTING TYPE
1.
Remove the dust proof caps (B,E,F,H,I on page 15)
2. Assemble the supply lid in its seat, connect the drain hose to the two-way valve for paint recirculation. (as COMMON 1)
3.
Connect the suction hose to the paint inlet joint. (Make sure the seal tape is taped around the suction hose)
Drain hose
CLOSE UP
Supply Lid
Suction hose
12
DIAPHRAGM PUMPS
COMMON
1. Connect the drain hose to the
2-way valve for paint recircu-
lation.
Drain hose
Band 3 spots wherever
you want
Suction hose
Fix the drain
hose with the
wing bolt.
DPS-120 C - DPS-90 G
C
1.
Assemble the following parts below in numerical order, and fix them to the stand.
3. Tire
4. Washer
2. Washer
Axle
1. Snap Pin*
5. Snap Pin*
Unscrew from pump lower adaptor the fitting bolt (M8) and assemble the handle on stand by using hex. bolt (M8) and
2.
bolt with hex. hole (M6).
Bolt with
hex. hole (M6)
Handle
Hex. Nut (M6)
Hex. Bolt (M8)
D
WALL MOUNTING TYPE
1. Remove the dust proof caps (B,E,F,H,I on page 15)
2. Detach the pump assembly from bracket by removing Hex. Bolts (M8).
3.
Flip the bracket and assemble the pump to the right position on bracket by using Hex. Bolts (M8).
4. Connect the drain hose to the two-way valve for paint recirculation. (as COMMON 1)
5.
Connect the suction hose to the paint inlet joint.
Wall bracket
Hex. Bolt (M8
E GRAVITY HOPPER TYPE (6 lt.)
Assemble the hopper set by means
the "U" suction tube, to the paint
1.
inlet joint of the pump mounted
on cart.
Connect the drain hose from two-
2.
way valve for paint recirculation to
hopper lid set directly.
DIAPHRAGM PUMPS
CART TYPE
*Put the end of the
pin into axle hole,
Hex. Nut
and push it inside
all the way by
using hammer.
"U" Bolt
As is when is fitted.
Band 3 spots wherever
you want
Suction hose
Drain hose
Suction
Band 3 spot
wherever you want
2
1
EN
hose
13