Non-functionality
If the material to be shredded jams:
This means that you have inserted too much paper
into the appliance (max. 8 Sheets 80g/m
• Slide the switch 7 into the position "REV" should
the paper to be shredded jam. The appliance
now goes into reverse and the material to be
shredded is returned.
• Pull the paper to be shredded out of the appliance
and then place the switch 7 at "AUTO".
• The appliance is now once again ready for
operation.
If the appliance suddenly ceases operation:
This means that the appliance is overheated and
the automatic safety cut-out has activated itself.
Attention:
Remove the plug from the mains power socket to
avoid an unintended starting of the appliance.
• Set the switch 7 to the "OFF" position.
• Allow the device to cool down.
• Insert the plug back into the socket.
• Switch the device on by setting the switch 7
to the "AUTO" position.
If the appliance doesn`t allow itself to be
switched on:
• Check that the plug is correctly connected to
a mains power socket.
• Try out a different mains power socket.
• The appliance is probably defective. Have the
appliance checked by qualified specialists.
• The appliance has overheated and triggered the
automatic safety switch-off. For this, proceed as
follows:
Attention:
Remove the plug from the mains power socket to
avoid an unintended starting of the appliance.
• Set the switch 7 to the "OFF" position.
2
).
• Allow the device to cool down.
• Insert the plug back into the socket.
• Switch the device on by setting the switch 7 to
the "AUTO" position.
Disposal
Dispose of the appliance through an approved dis-
posal centre or at your community waste facility.
Observe the currently applicable regulations.
In case of doubt, please contact your waste disposal
centre.
- 22 -
Do not dispose of the appliance in your
normal domestic waste. This product is
subject to the European guideline
2012/19/EU.
Dispose of packaging materials in an
environmentally responsible manner.