User Instructions - MORGAN Catering Equipment Somina Serie Instrucciones Para La Instalación, El Uso Y El Mantenimiento

B - Pilot spark-plug "Targhet" (fig. 3 pos. 5)
- Detach the high-voltage wire
- Unscrew the nut (fig. 3 pos. 8) using a 10 mm. spanner
- Replace the spark-plug
- Mount everything back by following the reverse order sequence
C - Thermocouple (Fig. 3 pos. 4)
- Undo the two screws (Fig. 7 pos. 8) with an 8mm wrench.
- Using a 9mm wrench, unscrew the thermocouple (Fig. 10).
- Fit it all back together in reverse order to the above.
D - Pilot burner (Fig. 3 )
- Remove the gas connection with a 10mm wrench (Fig. 3 pos. 2)
- Disconnect the high-voltage cable.
- Undo the two screws
- Remove the spark plug (Fig. 3 pos. 5) and the thermocouple (Fig. 3 pos. 4)
- Replace the pilot body (Fig. 3 pos. 6)
- Fit it all back together in reverse order to the above.
CAUTION: Check there is no gas leakage with the soap solution method.
E - Thermostat (Fig. 4)
- Take out the bulb (Fig. 4 pos. L) from the sheath.
- Disconnect the gas pipe from the valve outlet.
- Remove the 4 screws of the flange of the gas inlet.
CAUTION: Check the gas O-ring properly.
- Remove the thermocouple with a 9 mm wrench.
- Remove the pilot burner gas supply pipe with a 10mm wrench.
- Replace the old thermostat with a new one.
CAUTION: The push-buttons need to be on the left, don't forget the thermocouple break!
- Fit it all back together in reverse order to the above.
- Adjust the by-pass minimum screw (100% open!).
- Fit the valve bulb and the limiting thermostat bulb (Fig. 3 pos. M).
CAUTION: Check there is no gas leakage with the soap solution method.
Check that the oil temperature reaches 195°C with the thermostat on position 8.
F - Burner (Fig. 2)
- Remove the gas supply pipe).
- Undo the two screws with an 8mm wrench.
- Now you can replace the burner (or burners).
- Fit it all back together in reverse order to the above.
CAUTION: Check there is no gas leakage with the soap solution method.
G - Safety thermostat
- Check its operation and look for the cause that made the limiting thermostat trip.
- It is extremely simple to replace.
CAUTION: The thermostat interrupts the thermocouple circuit.
5.
Preliminary note
Before starting the unit, wash the inside of the basin and the baskets, proceeding as follows:
- Fill the basin up to its level with water and detergent, start heating and bring to the boil for a few minutes. Drain off the water
through the drain cock and rinse the basin thoroughly with clean water.
- If you use grease for frying, do not put it into the basin unless it is liquid; after use, drain off the grease while it is still liquid.
- When you need to heat solid lard, you need to do it extremely slowly, perforating the surface of the grease often to help it
expand and melt.
- During use, it is recommended not to cover the basin or pour salt or flavouring inside.
- Never start the unit without first filling the container with water. Failure to observe this instruction would cause severe
damage due to the bottom of the basin overheating.
All manuals and user guides at all-guides.com
- 17 -

USER INSTRUCTIONS

GB