Section 2 Using The Printer; Setting Up The Printer; Connecting The Printer Cable; Installing The Printing System Software - Kyocera KM-6230 Manual De Instrucciones

Section 2 Using the Printer

2-1 Setting up the Printer

(1) Connecting the printer cable

1 Caution
ALWAYS turn the printer and the computer OFF before
connecting the printer cable.
Turn the main switch, located on the left side of the printer,
OFF (O).
2
Connect a printer cable to the parallel interface connector or
Ethernet cable connector that is located on the right rear
side of the machine.
* If you are connected to a network through a Ethernet
connection, it is necessary to make the appropriate
network settings. (Refer to "(3) Network settings",
page 2-11.)
3
Turn the main switch, located on the left side of the printer,
OFF (O).
2-1
All manuals and user guides at all-guides.com

(2) Installing the Printing System software

Carry out the following procedure to install the Printing System
software that is appropriate to the operating system that is in use on
your computer.
The following Printing System software is available with this product.
• Printer Drivers
• Printer Manuals
• Printer Management Utilities
• PrinterMonitor
Refer to the corresponding section for the appropriate installation
procedure for each software package.
* The printer is compatible for use with computers running
Windows 98.
Refer to the explanations for Windows 95 when attempting to
perform setup and operational procedures under Windows 98.