Kyocera KM-6230 Manual De Instrucciones página 21

3 Use the numeric keys to enter "6200" (the network
management code).
* If the correct code is entered, the network setting screen
will appear.
* This 4-digit code can be changed. Refer to step 6 and
subsequent steps.
Default codes:6200
4
The currently registered IP address, Subnet Mask and
Gateway address will all be displayed. To change an
address, press the appropriate "Change" key to display the
corresponding setting screen.
* To change the network management code, proceed to
step 6.
Note: It is not possible to register or change more than one
of the addresses (IP address, Subnet Mask, Gateway
address) by a single operation at the same time.
* Since DHCP has been set to "ON" by default, the changes
made to the addresses will not be effective. For details,
refer to "DHCP".
5
The address will be separated into four blocks – each
consisting of three numbers. Press on the block to be
changed and then use the numeric keys to enter the desired
number. If the entered numbers are correct, press the "Enter
#" key. Once the complete address is entered as desired,
press the "End" key.
* The illustration on the right shows the screen used for
entering the IP address.
* After each address has been set, make sure that DHCP is
set to "OFF", then turn the power to the printer OFF, then
ON again. The entered addresses will be effective when
the printer is started up.
All manuals and user guides at all-guides.com
Section 2 Using the Printer
6 To change the network management code, press the " " key.
The network management code change screen will appear.
* If you do not want to change the code, press the "End"
key and the message display will return to the off-line
screen.
7
To change the displayed code, press the "Change" key and
then use the numeric keys to enter the desired 4-digit
network management code.
* It is recommended that you make some sort of notation of
the new code as, if it is forgotten, it will not be possible to
verify or make changes to the network settings.
8
Once all desired changes to the network settings are
complete, press the "End" key and the message display will
return to the off-line screen.
2-12