EN
Switching the device off
Stop the device.
Î
Switch the cutter deck off.
Î
Set the throttle to the middle position.
Î
Bring the cutter deck to the top position.
Î
Switch the engine off after 20 seconds.
Î
Switch the parking brake on.
Î
Close the fuel tap (if present, see engine manual).
Î
Remove the ignition key.
Î
Pushing the device O
Switch the engine off.
Î
Switch the parking brake off.
Î
Pull both gear release levers (left and right be-
Î
tween frame and engine) back and press them
downwards into the recess.
3 You can now push the device.
Note
Never tow the device. This can cause seri-
ous damage to the gears.
To continue driving, pull both gear release levers
Î
out from the recess and push them forwards.
Display cluster I (depending on the
model; optional)
Note
The indicators only come on when the en-
gine is running of if the ignition key is turned
from the STOP position.
Note
If the ignition switch is outside the STOP
position, the egg timer symbol of the display
cluster comes on/flashes to indicate that the
tractor operating hours are being recorded,
irrespective of whether the engine has been
started or not.
Note
If the oil change and air filter maintenance
occur at the same time, the oil change
indicator appears first and then the air filter
indicator.
Dependent on the model, the following indications
appear on the LCD display of the display cluster:
20
Display cluster I (depending on the model; optional)
Operating hours/battery voltage indication
When the ignition is switched on, the battery voltage
indicator is displayed for a short period, which
then changes to the operating hours indicator. The
operating hours are displayed in 1/10 hours.
The operating hours are always counted except
for when the ignition key is in the "Stop" position or
when it is removed.
Maintenance indicators
Note
means: The total operating hours are
displayed.
–
–
–
Change the engine oil immediately (see engine
Î
operating manual).
This indicator appears every 50 operating hours for
a period of 7 minutes.
–
–
The engine oil level is too low.
This indication is only displayed for devices whose
engine has an oil pressure switch.
Switch the engine off immediately and check
Î
the engine oil level (see the engine operating
manual). Top up the oil if required.
–
–
If you turn the ignition key to the
battery voltage is briefly shown and then the total
operating hours.
Charge the battery as quickly as possible.
Î
It may be necessary to have the charging system
Î
checked by a service centre for possible damage.
–
–
–
Perform air filter maintenance immediately (see
Î
engine operating manual).
This indicator appears every 25 operating hours for
a period of 7 minutes.
Changing the oil
Oil level
Battery voltage
position, the
Air filter mainte-
nance