Warnings And Cautions - Stryker Sidne Manual Del Usuario

3. Connect the Visum/StrykeCAM EDAM Power Supply to the DC jack on
the EDAM at the top right. Plug in the female end of the Hospital-grade
AC Power cord to the Power Supply. Plug in the male end of the AC
Power cord to a hospital-grade electrical outlet.
4. Turn ON the power on the Visum Power box. Ensure that the camera on
the wall panel is turned ON.
5. Power On the Sidne™ console (If the two Sidne™ interface cables are
connected to Sidne and the EDAM and the Visum Power box is ON,
Sidne will make an announcement of "Unknown Device Connected").
6. Install the Visum/StrykeCAM driver upgrade.
7. Sidne™ will shutdown at the end of the upgrade. Power On the Sidne™
and wait for the unit to say "Sidne™ ready". Caution: Sidne™ should say
"O. R. Lights Connected" and "Overhead Camera Connected" and the
EDAM LED should be a steady orange within a minute of powering On
the Visum Power box. If the LED continues to flash orange after 30
seconds, refer to the "Troubleshooting Guide" of this addendum for
instructions.
This completes the installation procedure.
Connecting the Visum Power Box

Warnings and Cautions

Please read this addendum and follow its instructions carefully. The words
warning, caution, and note carry special meanings and should be carefully
reviewed:
WARNING The personal safety of the patient or physician may be
involved. Disregarding this information could result in
injury to the patient or physician.
Caution Special service procedures or precautions must be followed to
avoid damaging the instrument.
Note
Special information to make maintenance easier or important
information more clear.
An exclamation mark within a triangle is intended to alert the user to the
presence of important operating and maintenance instructions in the lit-
erature accompanying the product.
A lightning bolt within a triangle is intended to warn of the presence of
hazardous voltage. Refer all service to authorized personnel.
2
All manuals and user guides at all-guides.com