Operation; Initial Check Before Start - HOLZMANN MASCHINEN TK255 Instrucciones De Servicio

OPERATION

16.1 Initial check before start

 Check that the speed of the machine is lower than the max. permissible speed of the
saw blade used.
 Check saw blade rotation and saw blade dimensions to match the machine.
 Check that the saw blade guard works properly.
 Check whether the connection to a dust collection system is installed.
 Check whether the stops/fences are set correctly and the saw blade is tightened.
 Check whether the machine is fixed on the working plate or a machine stand.
 Check whether the saw blade can run freely.
HOLZMANN MASCHINEN GmbH
Assembly rip-fence
The rip fence can be mounted to the left and right of the saw
blade.
The stop bar (4) is used for cutting narrow workpieces and for
cutting mitre angles and can be mounted to the left or right of the
rip fence.
To mount the stop rail (4), insert the 3 screws (S) into the holes
on the rip fence (the hexagonal head of the screw must be
positioned on the side where the stop bar is located).
Put on the washer and the wing nut (5+6) but do not tighten them
yet.
Thread the guide profile of the stop rail over the hexagonal heads
and then fix it with the wing nut.
Assembly mitre gauge
Insert the rail of the angle/mitre fence (1) into the guide groove
on the table (2).
The angle/mitre fence can be mounted to the left/right of the saw
blade.
Assembly dust hose
Connection to dust collection system
Connect your dust collection system to the
appropriate extraction hose by plugging it over the
dust collection adapter (1)..
www.holzmann-maschinen.at
- Release the locking lever (3) on the rip fence and insert the
rip fence into the rear guide on the saw table as shown.
- Fold the rip fence down and hook it into the front guide on
the saw table.
- The rip fence can be moved freely in its position when the
locking lever is unlocked.
- To fix it, press the locking lever down (rip fence fixed).
 Connect the extraction hose (1) to the saw
blade guard (3) and to the dust collection
connection adapter (2) on the back of the
machine.
OPERATION
33
TK255