Operation; Adjusting Cutting Height / Angle Of Saw Blade; Adjusting The Rip Fence; Adjusting Table Extension - HOLZMANN MASCHINEN TK255 Instrucciones De Servicio

16.2 Operation

16.2.1 Adjusting cutting height / angle of saw blade

16.2.2 Adjusting the rip fence

16.2.3 Adjusting table extension

HOLZMANN MASCHINEN GmbH
Adjusting cutting height:
Adjusting cutting angle
Release the locking lever (1) on the rip fence by
folding it up.
Move the rip fence until the desired distance to the
saw blade is achieved.
(read off the scale (3)) and then fix the locking lever.
Info about the scale:
The lower marking (2a) applies when the table
extension is not in use.
The upper scale (2b) applies when the table extension
is in use.
 The table extension (2) is used for wide workpieces.
 Release the table extension lock (15) and bring the
table extension (2) into the desired position with the
rails (1). At the desired position, fix the table in
position again with the table extension lock (1).
www.holzmann-maschinen.at
 The cutting height is adjusted by turning the
handwheel (2).
o counterclockwise: saw blade is set upwards
o clockwise: saw blade is set downwards
 Loosen the angle adjustment lock (1).
 Adjust the saw blade to the desired angle
 Fix the angle adjustment lock (1) again.
NOTICE
To ensure exact positioning and avoid
jamming / misalignment, press the stop
A against the guide when moving it.
OPERATION
34
TK255