Descargar Imprimir esta página

Check /Exchange Carbon Brushes; Overload-Protection; Storage; Disposal - HOLZMANN MASCHINEN TK255 Instrucciones De Servicio

Ocultar thumbs Ver también para TK255:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 41

17.2.5 Check /exchange carbon brushes

17.2.6 Overload-protection

17.3

Storage

Improper storage can damage and destroy important components. Only store
packed or unpacked parts under the intended ambient conditions!
When not in use, store the machine in a dry, frost-proof and lockable place to prevent the
formation of rust on the one hand and to ensure that unauthorised persons and in particular
children have no access to the machine.
17.4

Disposal

Observe the national waste disposal regulations. Never dispose of the
machine, machine components or operating materials (like oil,...) in residual
waste. If necessary, contact your local authorities for information on the
disposal options available.
If you buy a new machine or an equivalent device from your specialist
dealer, he is obliged in certain countries to dispose of your old machine
properly.

TROUBLESHOOTING

Danger due to electrical voltage! Manipulating the machine with the power supply
up can lead to serious injuries or death. Always disconnect the machine from the
power supply before carrying out any troubleshooting work!
Many possible sources of error can be excluded in advance if the machine is properly connected
to the mains.
If you are unable to carry out necessary repairs properly and/or do not have the required
training, always consult a specialist to correct/solve the problem!.
HOLZMANN MASCHINEN GmbH
Check the carbon brushes after the first 50 hours of operation
with a new machine or when new brushes are fitted. After
carrying out the first check, repeat the check every 10 hours of
operation. If the carbon is worn to a length of 6 mm, or if the
spring or contact wire is burnt or damaged, it is necessary to
replace both brushes. If it turns out that the brushes are usable
after removal, it is possible to refit them.
When servicing the carbon brushes, open the two latches
counterclockwise. Then remove the carbon brushes. Replace the
carbon brushes in reverse order.
NOTE
WARNING
www.holzmann-maschinen.at
Disconnect the machine from the power supply
Allow the machine to cool down
Check the machine for possible damage
Any damage must be repaired before switching on
again!
Reconnect the machine to the power supply
Press overload switch (k)
TROUBLESHOOTING
39
TK255

Publicidad

loading

Este manual también es adecuado para:

Tk255ms