Descargar Imprimir esta página

HOLZMANN MASCHINEN TK255 Instrucciones De Servicio página 40

Ocultar thumbs Ver también para TK255:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 41
Fault
Motor does not run
Saw blade gets stuck
Material kickback
Cutting angle isn't
correct / mitre angle
isn't correct
Poor cutting results
HOLZMANN MASCHINEN GmbH
Possible cause
(Extension) cable defective or too
long.
Power supply (voltage, frequency).
Motor defect
ON-OFF switch defective
Carbon brushes defective
Overload protection activated
Incorrectly adjusted riving knife
Not suitable saw blade
Blunt saw blade
Material too hard or cutting too
fast.
Blunt saw blade
Saw blade incorrectly assembled
Incorrectly adjusted rip fence
Incorrectly adjusted mitre fence
Wrong saw blade
Incorrect cutting speed
www.holzmann-maschinen.at
correction
Unplug, check with another machine. Check
minimum cross-section!
Match power supply to requirements from
Technical Data
Replace or ask for service
Repair/replace switch
Replace carbon brushes
see chapter Overload protection
Adjust riving knife Distance 3-8 mm to circular
saw blade
Use a circular saw blade recommended for your
material
Replace sawblade
Adjust cutting speed to workpiece hardness &
motor power!
Replace saw blade
Check and correct
adjust
Change saw blade
Adjust cutting speed
40
TK255

Publicidad

loading

Este manual también es adecuado para:

Tk255ms