Descargar Imprimir esta página

Adjusting Angle/Mitre Stop; Switching Machine On/Off; Existing Storage Places; Operation Modes - HOLZMANN MASCHINEN TK255 Instrucciones De Servicio

Ocultar thumbs Ver también para TK255:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 41

16.2.4 Adjusting angle/mitre stop

16.2.5 Switching machine ON/OFF

16.2.6 Existing storage places

16.3 Operation modes

Sawing straight cuts
– Position the rip fence to the desired cutting width.
- Place the workpiece on the saw table in front of the saw blade cover.
- Adjust the saw blade height so that the upper teeth are approx. 3-6 mm above the workpiece.
- Switch on the machine
- Saw through the workpiece at a steady feed rate. If you apply too much pressure, the saw
blade tips may overheat and the workpiece may be damaged.
- Switch off the machine when you have finished sawing and wait until the saw blade has come
to a complete stop..
HOLZMANN MASCHINEN GmbH
Release the angle stop lock (2).
Set the desired angle
Lock the angle stop (2) again.
The position of the fence can be adjusted by
loosening the screw (2) and sliding it.
ATTENTION: Check the distance to the saw blade and
readjust if necessary.
Switch the machine ON:
Press the ON button (I)
Switch the machine OFF:
Press the ON-OFF switch (0)
A spare saw blade is stored with the spare saw blade
attachment (1).
The rip fence is stored in slot 2
The push stick is stored in slot 3.
The power cord is stored in the power cord holder
(4).
The tool is stored in the tool compartment
The angle stop is stored in the slot (5)
www.holzmann-maschinen.at
OPERATION
35
TK255

Publicidad

loading

Este manual también es adecuado para:

Tk255ms